Configuring The Data Logger; General Settings - Magna Telemotive blue PiraT2 User Manual

blue PiraT2 / 5E / Mini
Datum: 16.09.2016
Seite 63 von 77
Camera User Guide
13

Configuring the data logger

13.1 General settings

The logger should be configured as DHCP server, if it is not already configured accordingly (de-
fault value).
Therefore click on the application [Open configuration] (5) in the Telemotive System Client.
Expand the folder [General] in the window to the right and click on [Network settings]. Enable
the <DHCP mode> (o) DHCP server.
Figure 13.1: Selecting an application in the Telemotive System Client
Figure 13.2: Setting the network settings in the Telemotive System Client
Please be sure about the setting of the logger's standby.
You can activate or deactivate the automatic standby at [General]  [Standby]. If active, there
are two different time settings for network connection.
If the data logger is not connected to a network at the front Ethernet port and does not receive
any data during the timeout entered in the upper text field, then it shuts down and enters
standby mode.
If the data logger is connected to a network at the front Ethernet port with active link and does
not receive any data during the timeout entered in the lower text field, then it shuts down and
enters standby mode.
This has important implications when using the camera function since Ethernet is required. If
you activated the automatic standby, no further channels are connected or they are inactive, the
bP2-Mini_Camera_UserGuide_V2.4.1.doc