Western Digital OpenFlex F3x00 Manual page 31

Installation Guide
Figure 41: Release Handle Engage
c. Rotate the release handle up and press it into the OpenFlex F3x00 to secure it into the slot.
When it is fully installed the user will feel the handle snap and lock into place.
Figure 42: Secure OpenFlex F3x00
d. Verify that the F3x00 is securely latched into the chassis by pulling on the latch and ensuring
the device does not move when pulled. Reinstall the device if it is not securely installed into
the chassis.
e. Repeat these steps to install each device in the same way as the first, ensuring that the
correct installation order is followed.
Step 3 : Verify the health of the system using the OCGUI:
Note: The blue and amber LEDs will illuminate, followed shortly by the green
LED. All three LEDs will remain illuminated for just over a minute until the
device is initialized. Once the device is initialized, the amber and blue LEDs
will turn off, and the Device Status LED that encircles the device release button
will illuminate, indicating that the SPDK services are running. Wait time is not
required between the installation of multiple OpenFlex F3x00 devices.
1. Installation
1.6 Device Installation
26