Table of Contents
Advertisement
6. Once the best position has been achieved, tighten the set (grub) screw.
7. If the camera power cable and video cable have been disconnected, reconnect those
cables.
8. Reinstall the HPLC Chip Cube Interface on the LC/MS instrument.
9. The new top plate can now be installed.
10. Locate the new top plate (part number G1982-60004) and install it on the HPLC interface.
Use the new screw (part number 0515-1644) to secure the top plate in place.
Page 19 of 33
This is the actual
illumination LED spot
showing the desired
alignment.
18 July 2011
Advertisement
Table of Contents
