Safety Tips - Hill-Rom Prima Procedural Light Service Manual

Safety Tips

Chapter 1: Introduction

Safety Tips

WARNING:
After completing a repair of the Prima™ Procedural Light, make sure
the unit is in proper operating condition. Failure to do so could result in
personal injury or equipment damage.
WARNING:
Only facility-authorized maintenance personnel should troubleshoot the
Prima™ Procedural Light. Troubleshooting by unauthorized personnel
could result in personal injury or equipment damage.
WARNING:
The Prima™ Procedural Light operates at a high temperature. Allow the
unit to cool for at least 30 minutes before performing any preventive
maintenance or repair procedures. Failure to do so could result in
personal injury.
WARNING:
Use only Hill-Rom approved replacement lamps. Failure to do so will
affect the operating specifications of the Prima™ Procedural Light. Use
of a higher wattage and/or lower voltage lamp may also cause a fire
hazard, resulting in personal injury or equipment damage.
WARNING:
The rotating arm is spring loaded. When removing the lamp head/yoke
assembly, ensure that the rotating arm is restrained. Failure to do so
could result in personal injury or equipment damage.
WARNING:
Ensure the rotating arm is supported before removing the retaining ring.
Failure to do so could result in personal injury or equipment damage.
WARNING:
Operate the Prima™ Procedural Light only with the lens assembly in
place. Failure to do so could result in personal injury.
Page 1 - 10
DRAFT 6/4/99
Prima™ Procedural Light Service Manual (man247ra)