Installation; Safety Cable - ETC ColorSource Linear Installation Manual

ETC Installation Guide
ColorSource Linear v1.7

Installation

Mounting
The ColorSource Linear ships with a pair of floor trunnions for mounting.
Note:
that fixtures can be lined up end-to-end, if needed.
You also have the option of using clamps with the trunnions to hang the
fixture. Attach the clamps to the holes in the trunnion feet (see figure on
page 5 ).
The ColorSource Linear 1 has two additional mounting options. Contact your
local dealer for more information.
Yoke with C-clamp (7414K1017)
•
Double yoke with C-clamp for mounting two fixtures (7414K1018)
•

Safety Cable

Two safety cable anchor points are
provided on the fixture housing.
The anchor points also include two
cutouts that can be used for cable strain
relief.
Connectors
Power: Two powerCON
•
connectors for power in and thru
Data (DMX512/RDM): Two five-
•
pin XLR connectors OR two
RJ45 connectors for data in and
thru
Conversion cables are available from ETC. Please contact your ETC customer
service representative and request part number W6538 for RJ45 to female
XLR or part number W6539 for RJ45 to male XLR.
Connector locations
Linear 1: Power connectors on one side of the fixture and data
•
connectors on the other
Linear 2 and Linear 4: Power and data connectors on each end (to
•
facilitate daisy-chaining)
Note:
ColorSource Linear
Ensure that the trunnions are installed with the feet inward so
This fixture is not Ethernet/data network compatible.
Safety cable
anchor point
®
Cutout for
cable strain relief
Page 5 of 20
C-clamp
attachment
point
ETC