Table of Contents
Advertisement
ETC Installation Guide
ColorSource PAR Pearl v1.7
Installation
Emergency lighting considerations
Luminaires that are used in emergency lighting applications must provide a
minimum illumination level over the identified means of egress path in
accordance with the Life Safety Code
intended to serve this purpose must be mounted at a height where it will not
readily be subjected to tampering by unauthorized personnel and where the
minimum required illumination level over the egress path can be achieved.
The ETC DMX Emergency Bypass Controller that is driving the luminaire upon
loss of utility power must be programmed to drive the ColorSource PAR Pearl
to full illumination.
Mounting
The ColorSource PAR Pearl ships with a standard yoke for mounting with a
C-clamp. An expandable floor stand yoke is available as an optional
accessory. Contact your local dealer for more information.
Safety cable
The safety cable (or other approved
safety device) must be attached to the
fixture. Attachment loops are
provided on the rear of the fixture
housing. Take care to leave as little
slack as possible in the safety cable to
avoid catching the yoke of the fixture.
Connectors
• Power: Two powerCON
• Data (DMX512/RDM): Two five-pin XLR connectors
connectors for data in and thru
Conversion cables are available from ETC. Please contact your ETC customer
service representative and request part number W6538 for RJ45 to female
XLR or part number W6539 for RJ45 to male XLR.
Note: This fixture is not Ethernet/data network compatible.
Note: The ColorSource PAR Pearl is not self terminating. You
ColorSource PAR Pearl v1.7
®
connectors for power in and thru
must terminate the last fixture in line with a 120 Ohm
resistor. XLR terminators are not available from ETC.
To purchase an RJ45 terminator, please contact ETC
customer service and request part number N4086.
Page 4 of 16
®
, NFPA 101. A luminaire that is
Safety cable
attachment
loop
OR
two RJ45
ETC
Advertisement
Table of Contents
Need help?
Do you have a question about the ColorSource PAR Pearl and is the answer not in the manual?
Questions and answers