Set The Dmx Address - ETC ColorSource Linear Installation Manual

ETC Installation Guide
ColorSource Linear v1.7
Grouping button
and LED indicators
Mode button
Power Up
Press any button to wake the display. The display shows the DMX address.
See Set the DMX Address below
You can press the Mode button to access the Presets/Sequences menu. See
Play Presets and Sequences on page 12
Adjust the Tilt
The fixture can be tilted up and down as needed.
1. Loosen, but do not remove the two trunnion locking knobs.
2. Tilt the fixture to the desired angle.
3. Tighten the trunnion locking knobs.
Set the DMX Address
1. Press any button to wake the display. The display shows the DMX
address.
2. Use the Up and Down buttons to select the DMX address for the
fixture.
You can also use RDM for DMX addressing. See
ColorSource Linear
Linear 2 and Linear 4
.
.
Page 7 of 20
Power and data
connectors are
paired on each
side to facilitate
daisy-chaining
Up and Down
buttons
User interface
(display)
Use RDM
.
ETC