Advertisement
•
Air fitting: The ½" air impact wrench should be equipped with a ¼" NPD male quick connector
(not included). To prevent accidental cycling even though disconnected, the tool must always
be connected to the air supply in a way that all air pressure within the tool is released when the
coupling is disconnected.
Caution!
•
All air pipe components (including hoses, pipe, connectors, filters, regulators etc.) must be rated
for a working pressure of 90 psi.
•
Disconnect the tool from the air supply before performing maintenance, leaving the work area,
moving the tool to another location or handing it to another person.
Preparing the tool
•
Drain water from the air compressor tank and any condensation from air lines. (Please refer to
the operation manual of the air compressor)
•
Lubricate the tool. (Please refer to the maintenance section in this manual)
•
Select the necessary impact sockets. (The sockets must match the size of the drive on the air
impact wrench.)
•
Connect air impact wrench to the air source using the recommended hose size.
Caution!
•
Keep the tool pointed away from yourself and any other person at all times.
•
Never use a tool that leaks air or needs repair.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 61134
Page 7
05
2021-1
Advertisement
