Advertisement
Main components of ½" air impact wrench
Operating procedures
Setting up the air source
•
The ½" air impact wrench is designed to operate on clean, dry, compressed air, regulated at
90 psi. The preferred system would include a filter, a pressure regulator and an automatic oiler
located as close to the tool as possible. Within 15 feet (4.5 m) is ideal. Do not use bottled air or
gases (see Fig. 2).
№ Name
1
Air impact wrench
2
Quick coupling
3
Air hose
4
Regulator
All compressed air contains moisture and other contaminants that can harm the internal components of
the tool. An air filter will remove most of these and significantly extend the life of the tool. Ensure the in-
line oiler has sufficient oil. If an in-line oiler is not available, place 2 drops of oil into the air inlet of the
tool at the beginning of each workday. More than this will be expelled from the exhaust of the tool during
using (Fig. 3).
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Letter
A
B
C
D
E
№ Name
5
Lubricator
6
Filter
7
Air inlet
Item 61134
Name
Anvil
Control valve
Trigger
Air regulator
Air inlet
Page 6
05
2021-1
Advertisement
