Advertisement
•
Use this tool with both hands only. Using tools with only one hand can result in loss of control.
•
Do not lay down the tool until it has come to a complete stop. Moving parts can grab the surface
and pull the tool out of your control.
•
Always handle the tool with care:
◦ This tool is a working implement; only use it as such.
◦ Never pull the trigger unless nose is directed toward the work.
◦ Keep others in a safe distance from the tool while the tool is in operation as accidental
actuation may occur possibly causing injury.
Safety of air supply and connections
•
Do not use any type of reactive gases like oxygen carbon dioxide and combustible gases as a
power source. Use filtered, lubricated, regulated compressed air only. Use of a reactive gas
instead of compressed air may cause the tool to explode which will cause death or serious
personal injury.
•
Only use a pressure-regulated compressed air source to limit the air pressure supplied to the
tool. The regulated pressure must not exceed 90 psi. If the regulator fails, the pressure must
not exceed 90 psi. The tool could explode which will cause death or serious personal injury.
•
Always disconnect air source:
◦ before making adjustments;
◦ when servicing the tool;
◦ when the tool is not in use;
◦ when moving to a different work area as accidental actuation may occur causing injury.
•
Never connect the tool to an air source that may exceed 90 psi. Over pressurizing the tool may
result in bursting, abnormal operation, breakage of the tool as well as serious personal injury.
Use only clean, dry, regulated compressed air at the rated pressure or within the rated pressure
range as marked on the tool. Always verify prior to using the tool that the air source has been
adjusted to the rated air pressure or within the rated air-pressure range.
Technical specifications and accessories
Square drive
Idle speed
(inch)
½
•
1× impact wrench
•
1× quick coupling
•
1× oiler
•
1× extension
•
1× 4 mm hexagon socket wrench
•
1× transport case
•
10× sockets
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Max. torque
(rpm)
(Nm)
320
7000
(236.02 ft-lb)
Air consump-
Air inlet (inch)
ℓ
⁄
tion (
)
min
140
(5 cfm)
Item 61134
Max. air pres-
sure (bar)
6
¼
(87.02 psi)
Page 5
05
2021-1
Advertisement
