Advertisement
Quick Links
Operation Manual
Workshop Press
61976, 61977, 61978
Illustration similar, may vary depending on model
Read and follow the operating instructions and safety information before using for the first time.
Technical changes reserved!
Due to further developments, illustrations, functioning steps and technical data can differ insignific -
antly.
Updating the documentation
If you have suggestions for improvement or have found any irregularities, please contact us.
Advertisement
Related Manuals for WilTec 61976
Summary of Contents for WilTec 61976
- Page 1 Operation Manual Workshop Press 61976, 61977, 61978 Illustration similar, may vary depending on model Read and follow the operating instructions and safety information before using for the first time. Technical changes reserved! Due to further developments, illustrations, functioning steps and technical data can differ insignific - antly.
- Page 2 All rights reserved. The WilTec Wildanger Technik GmbH cannot be held accountable for any possible mistakes in this operating manual, nor in the diagrams and figures shown.
- Page 3 The hydraulic cylinder is under pressure and must not be opened with force. © by WilTec Wildanger Technik GmbH Item 61976, 61977, 61978 Page 3 http://www.WilTec.de http://www.aoyue.eu...
-
Page 4: Specifications
Check all hydraulic connections/ lines before use and make sure that there are no damages. Specifications For aligning, bending and straightening work Optimally height-adjustable © by WilTec Wildanger Technik GmbH Item 61976, 61977, 61978 Page 4 http://www.WilTec.de http://www.aoyue.eu 2021-1 http://www.teichtip.de... -
Page 5: Troubleshooting
Warning! Should you detect any kind of structural failure, stop using the shop press immediately. If necessary, have the unit repaired by a qualified service technician. © by WilTec Wildanger Technik GmbH Item 61976, 61977, 61978 Page 5 http://www.WilTec.de http://www.aoyue.eu... - Page 6 the release valve. Check the oil level. It must be just below the oil filling hole. If necessary, fill up with high-quality hydraulic oil. © by WilTec Wildanger Technik GmbH Item 61976, 61977, 61978 Page 6 http://www.WilTec.de http://www.aoyue.eu 2021-1 http://www.teichtip.de...
- Page 7 Hexagonal bolt M10×25 Square steel connection Washer ⌀14 Hydraulic cylinders Spring washer ⌀14 Handle Hexagonal nut M14 Handle Cover Work area Work table Spring © by WilTec Wildanger Technik GmbH Item 61976, 61977, 61978 Page 7 http://www.WilTec.de http://www.aoyue.eu 2021-1 http://www.teichtip.de...
- Page 8 Hexagonal bolts M12×30 Coupling nut Hexagonal bolts M10×20 Square steel connection Work area Hydraulic cylinder Washer ⌀16 Handle Spring washer ⌀16 Handle cover Hexagon nut M16 © by WilTec Wildanger Technik GmbH Item 61976, 61977, 61978 Page 8 http://www.WilTec.de http://www.aoyue.eu 2021-1 http://www.teichtip.de...
- Page 9 Press plate Important notice : The reprint or reproduction, even of excerpts, and any commercial use, even in part of this instructions manual require the written permission of WilTec Wildanger Technik GmbH. © by WilTec Wildanger Technik GmbH Item 61976, 61977, 61978 Page 9 http://www.WilTec.de...