Advertisement
Quick Links
Operation Manual
Portable Sandblaster
62297
Illustration similar, may vary depending on model
Read and follow the operating instructions and safety information before using for the first time.
Technical changes reserved!
Due to further developments, illustrations, functioning steps and technical data can differ insignificantly.
Updating the documentation
If you have suggestions for improvement or have found any irregularities, please contact us.
Advertisement
Related Manuals for WilTec 62297
Summary of Contents for WilTec 62297
- Page 1 Operation Manual Portable Sandblaster 62297 Illustration similar, may vary depending on model Read and follow the operating instructions and safety information before using for the first time. Technical changes reserved! Due to further developments, illustrations, functioning steps and technical data can differ insignificantly.
- Page 2 All rights re- served. The WilTec Wildanger Technik GmbH cannot be held accountable for any possible mistakes in this operating manual, nor in the diagrams and figures shown.
- Page 3 • wearing loose clothing or jewellery; tie long hair together to keep it away from moving parts. © by WilTec Wildanger Technik GmbH Item 62297 Page 3 http://www.WilTec.de...
- Page 4 Avoid skin contact with the dusts created. Sufficient ventilation is required. Read and under- stand the following measures to reduce the exposure to crystalline silicon dioxide within the work area and to avoid silicosis-related injuries and death. © by WilTec Wildanger Technik GmbH Item 62297 Page 4 http://www.WilTec.de...
- Page 5 ◦ crystalline silica from brick, cement, and other masonry, ◦ arsenic and chromium from chemically treated wood. Scope of delivery • Hose (2.5 m) • Tank • Cover • Hopper © by WilTec Wildanger Technik GmbH Item 62297 Page 5 http://www.WilTec.de http://www.aoyue.eu 2021-1 http://www.teichtip.de...
- Page 6 3. Place a washer and a counter nut on the end of the screw and tighten it by hand. 4. Align both holes in the upper part of the hose holder and the holes in the abrasive tank. © by WilTec Wildanger Technik GmbH Item 62297 Page 6 http://www.WilTec.de...
- Page 7 8. Point the sandblasting gun on the workpiece so that the material hits the workpiece surface at an angle of approx. 45°. 9. Press the control lever of the sandblasting gun to release the material. © by WilTec Wildanger Technik GmbH Item 62297 Page 7 http://www.WilTec.de...
- Page 8 After 10–12 operating hours, the nozzle should be controlled for wear. The nozzle, wearing out over time, should be replaced with the opening not being round any more or the abrasive no longer flowing evenly. © by WilTec Wildanger Technik GmbH Item 62297 Page 8 http://www.WilTec.de...
- Page 9 Lock pin Important notice: The reprint or reproduction, even of excerpts, and any commercial use, even in part, of this instruction manual require the written permission of WilTec Wildanger Technik GmbH. © by WilTec Wildanger Technik GmbH Item 62297 Page 9 http://www.WilTec.de...