INSTALLATION GUIDE
ROLLER SHADES
LIFT SYSTEM: MOTORIZATION
The difficulty level of this installation is ranked at Level 2. You got this!
If you have questions or get stuck, call our Customer Care Team at 888-257-1840, or email customercare@selectblinds.com.
EXPOSED ROLL
BRACKETS
PENCIL
TAPE MEASURE
1.
MOUNTING THE BRACKETS
MOUNTING EXPOSED ROLL BRACKETS
The motor is hidden inside the roller tube on the right end of
the shade. The MOTOR BRACKET goes on the right side of your
window, and the PIN BRACKET goes on the left side. Regardless
of your roll position (standard or reverse roll), the brackets are
positioned the same.
EXPOSED ROLL - INSIDE MOUNT
NOTE:
The steps for mounting an exposed roll shade are the
same, regardless of the bracket style you received.
1. At the top-right corner of the window, measure how deep you
wish to place your bracket (at least 2 1/4" required), and make a
mark with your pencil. Repeat this step at the top-left corner of
the window, using the same depth measurement.
2. Set your motor bracket in the window so that the back edge
aligns with your mark. Hold the bracket in position and use your
pencil to mark through the top screw holes. Repeat this step
with your pin bracket on the left side of the window.
3. Pre-drill holes with a 5/64" drill bit at your previous marks on
each side of the window.
®
Simple. Smart. Custom.
HARDWARE AND PARTS INCLUDED
STANDARD CASSETTE
LARGE CASSETTE
BRACKETS*
BRACKETS*
*The quantity of brackets you receive will depend on the width of your cassette headrail.
POWER DRILL
INSTALLATION GUIDE | ROLLER SHADES
BATTERY CHARGER
TOOLS REQUIRED
5/64" DRILL BIT
PHILLIPS BIT
TOP
BACK
PIN SLOT
PIN BRACKET
(LEFT)
Simple. Smart. Custom.
1
2
3
4 5 6
REMOTE CONTROL
(1, 6, AND 16-CHANNEL)
PHILLIPS SCREWDRIVER
LEVEL
TOP
TAB
MOTOR BRACKET
(RIGHT)
UPDATED NOVEMBER 2020
®
INSTALLATION
SCREWS
STEP LADDER
BACK
1