SelectBlinds ROLLER SHADES Installation Manual page 3

MOUNTING CASSETTE HEADRAIL BRACKETS
NOTE: The roller shade tube is pre-installed in the cassette headrail, which simply snaps onto the provided hardware. You will receive two or more
cassette brackets, depending on the width of your shade. STANDARD CASSETTE BRACKETS are included for cassette headrails 96" wide or
smaller. LARGE CASSETTE BRACKETS are included for headrails over 96" wide.
SCREW HOLES
(INSIDE MOUNT)
BACK
SCREW HOLES
(OUTSIDE MOUNT)
STANDARD CASSETTE BRACKET
CASSETTE HEADRAIL - INSIDE MOUNT
1. At the top corners of the window, measure inward and mark with your pencil 2" - 4" from each side. If you have additional brackets, make an
additional mark for each one, evenly spaced between the outer marks.
2. Next, you'll need to measure how deep to place your
brackets in the window. Starting at one of your marks,
measure back at least 2 5/8", and make a mark with your
pencil. If you want the front of the cassette to be flush with
the wall, measure back 3 1/4" and make a mark. Repeat this
step until you've marked the same depth measurement for
each bracket.
3. Position a bracket at the top of the window so that the
back aligns with your mark. Make sure the front end of the
bracket is parallel with the top edge of the window, then use
your pencil to mark where the screws will go. Repeat this
step until you've marked the screw holes for each bracket.
4. Pre-drill the screw holes with a 5/64" drill bit at your
marks for each bracket location. Before you mount the
brackets, you may want to erase any pencil marks that
remain on the wall or window.
5. Line up your first bracket with the screw holes, and insert
two screws to secure the bracket to the mounting surface.
Repeat this step for any remaining brackets. When all
brackets are secure, you're ready to mount the shade into
the window (see pages 4 - 5).
®
Simple. Smart. Custom.
TOP FRONT
2" - 4"
INSTALLATION GUIDE | ROLLER SHADES
TOP
SCREW HOLES
(INSIDE MOUNT)
BACK
SCREW HOLES
(OUTSIDE MOUNT)
LARGE CASSETTE BRACKET
2" - 4"
FRONT
UPDATED NOVEMBER 2020 3