SelectBlinds ROMAN SHADES Installation Manual

INSTALLATION GUIDE
ROMAN SHADES
LIFT SYSTEMS: CORDLESS LIFT
The difficulty level of this installation is ranked at Level 1. A piece of cake!
If you have questions or get stuck, call our Customer Care Team at 888-257-1840, or email customercare@selectblinds.com
HARDWARE AND PARTS INCLUDED
INSIDE MOUNT OUTSIDE MOUNT
BRACKET BRACKET
MOUNTING THE BRACKETS
1.
NOTE: Your roman shade has pre-drilled slots in the top of the headrail. You
will use these slots as a guide for your bracket placement.
INSIDE MOUNT
1. Grasp the shade by the headrail and hold it up inside the top of the window. Set it
back until the front of the shade is flush with the wall. Hold the shade in place, and
with a pencil, make a mark through each hole in the headrail. Set the shade aside.
2. Take a bracket and center the drop-bolt over each mark. Use the holes in the top
of the bracket to mark where your two screws will go.
3. Pre-drill the screw holes for each bracket with a 5/64" drill bit. Align the brackets
with the holes, and use a 1/4" nut driver bit (or Phillips drill bit) to securely fasten the
screws.
OUTSIDE MOUNT
1. Center and hold the headrail at least two inches above the
window. While keeping the shade level, make a small line with
your pencil just above each of the pre-drilled holes in the headrail.
Set the shade aside.
2. Align the top edge of a bracket along each mark, and use the
holes in the back of the bracket to mark where your two screws
will go.
3. Pre-drill the screw holes for each bracket with a 5/64" drill bit.
4. Align the brackets with the holes, and use a 1/4" nut driver bit
(or Phillips drill bit) to fasten the screws in place.
®
Simple. Smart. Custom.
SCREWS WINGNUT
INSTALLATION GUIDE | ROMAN SHADES
TOOLS REQUIRED
PENCIL TAPE MEASURE
5/64" DRILL BIT
1/4" NUT DRIVER BIT
TOP OF HEADRAIL
PRE-DRILLED SLOTS
FRONT
DROP-BOLT
FRONT
Simple. Smart. Custom.
POWER DRILL STEP LADDER
PHILLIPS DRILL BIT
LEVEL
Predrilled Slots
2" - 4"
BACK
UPDATED SEPTEMBER 2020
®
1