SelectBlinds ROMAN SHADES Installation Manual

INSTALLATION GUIDE
ROMAN SHADES
LIFT SYSTEMS: CORDLESS LIFT
The difficulty level of this installation is ranked at Level 1. A piece of cake!
If you have questions or get stuck, call our Customer Care Team at 888-257-1840, or email customercare@selectblinds.com
HARDWARE AND PARTS INCLUDED
INSTALLATION HANDLE
BRACKET*
*The quantity of brackets you receive will depend on the width of your roman shade.
1.
MOUNTING THE BRACKETS
ATTACH THE PLEAT STIFFENERS
NOTE: Cordless shades are lifted and lowered manually. Pleat
stiffeners are used to make sure your shade operates and folds
together perfectly. We recommend attaching the pleat stiffeners
before mounting your brackets.
1. On the backside of the shade, locate the plastic braces attached
to the bottom corners of the shade.
2. Press each end of the stiffener into the grooves on the plastic
brackets. DO NOT press on the center of the stiffeners. This can
break them.
INSIDE MOUNT
1. Measure 2"- 4" in from each side of the window frame, and mark
once with a pencil for your outer brackets. The front of the bracket
will face out from the window, and the back of it will hang down
parallel to the window.
NOTE: Leave marks for any additional brackets you need, evenly
spaced between your first two marks.
2. Center the brackets over your marks, and set them back until the
front of the bracket meets the edge of your window. Mark through
the top holes in the bracket with your pencil. This is where your
screws will go.
3. At each of your marks, pre-drill holes with a 5/64" drill bit. Align
each bracket with your screw holes and drill the screws securely
into place.
®
Simple. Smart. Custom.
SCREWS
PLEAT STIFFENERS
INSTALLATION GUIDE | ROMAN SHADES
TOOLS REQUIRED
PENCIL TAPE MEASURE
PHILLIPS SCREWDRIVER
LEVEL
BACK
Simple. Smart. Custom.
POWER DRILL
PHILLIPS DRILL BIT
STEP LADDER
5/64" DRILL BIT
SWING-ARM
FRONT
UPDATED SEPTEMBER 2020
®
1