SelectBlinds Fauxwood Blind Installation Instructions

Basswood & Fauxwood Blind
Installation Instructions
Please follow these Installation Instructions
You will need a pencil, tape measure, drill, screwdriver, pliers, and appropriate fasteners.
Step 1: Choose the Correct Fastener
1 ½" #8 Hex Head
Wood Screws (Included)
Step 2: Prepare Brackets
End Box
Installation Brackets
Prepare box brackets for installation:
Open the front of the bracket by
pressing on the bottom of the
bracket to release the locking tab
while lifting the front gate.
Step 3: Mark the Bracket Locations
(For Outside Mount Installations)
Position the box brackets at each end of the headrail. When using a
single center support bracket, center it between the box brackets. For
more than one center support bracket, space the support brackets
evenly, not more than 30" apart. Make sure the brackets will not
interfere with the cord mechanism or any other internal parts. Mark
the bracket for mounting hole locations, making sure they are square
and equally spaced. For outside mount installations, use a level to
check for levelness.
Center Support
Bracket
Alternative fasteners should be used for aluminum or
concrete installations
(Not Included with Blinds)
(For Inside Mount Installations)
Position the box brackets at each end of the headrail. Depending on
the installation location, box brackets can be attached using the top,
back, or side holes. When using a single center support bracket, center
it between the box brackets. For more than one center support
bracket, space the support brackets evenly, not more than 30" apart.
Make sure the brackets will not interfere with the cord mechanism or
any other parts. Mark the location of the desired bracket mounting
holes, making sure that they are square and equally spaced.