18.7.5 Menu 9.8.9 - Configuration of end points for the tubular motor
Set the lower end point.
4.
Press and hold the set button. The roller
a)
shutters travel downwards.
Release the button as soon as the desired
b)
end point is reached.
Back to system menu.
5.
The end points will only be stored if:
◆ the tubular motor is allowed to run for at least four seconds before an end point is reached.
◆ the configuration process is undertaken starting from the end point that is to be changed.
Check the correct setting of the end points directly after completing the configuration process
with the help of the operating keys.
18.7.6 Menu 9.8.0 - Display software version
This menu enables the current software
version for the DuoFern HomeTimer to be
displayed.
Select and open menu 9.8.0 - Software
1.
version.
Subsequently the current software
2.
version will be displayed.
Back to system menu.
3.
The lower end point is thereby stored for
the motor.
EN
63