18.2 Menu 9.2 - Configure motor running time
Manually setting the running time
Fully close the roller shutters.
a)
Subsequently move the roller shutters to
b)
the upper end point and make a note of the
time required.
Enter and confirm the measured running
c)
time in menu 9.2.
18.3 Menu 9.3 - Configure ventilation position [ ]
If you do not want the roller shutters to close fully to the lower end point, you can use this
function to configure an arbitrary position (e.g. as ventilation position).
When closing automatically, the roller shutters will stop at the ventilation position, however,
they can subsequently be closed completely via manual operation.
i
The running time must be configured prior to setting the ventilation position, see page 52.
Select and open menu 9.3 - Ventilation
1.
position.
2.
Select a DuoFern actuator.
54
EN
e.g. 15 sec.