16.2 DuoFern radio code
The radio code enables DuoFern actuators to be set to registering mode. This is especially
useful for commissioning flush-mounted devices, as it is not necessary to dismantle them.
◆ The DuoFern actuator radio code is only active for a maximum period of 2 hours after
connecting to the power for security reasons.
◆ The radio code is located on the bottom of the respective DuoFern actuator and on a
label attached to the packaging.
◆ For DuoFern radio tubular motors you will find the radio code on the motor and on a
label fitted to the connecting cable.
Please read the operating instructions for the relevant DuoFern actuator in order to
activate the registering procedure.
Registering a DuoFern actuator per radio code to the DuoFern HomeTimer
Select and open menu 9.9.7 - Radio code.
1.
Successively enter the ten digit* radio code
2.
and confirm.
Only the flashing digit can be entered in
each case.
* If you have a 6-digit radio code, enter a
zero (0) for each of the 7th to 10th digits.
EN
33