Menu 9.8.9 - Configuration Of End Points For The Tubular Motor - RADEMACHER DuoFern HomeTimer 9498-UW Instruction Manual For The Electrical Connection And For Commissioning

18.7.5 Menu 9.8.9 - Configuration of end points for the tubular motor

You can use your DuoFern HomeTimer to configure the end points for an electronic
RADEMACHER tubular motor.
i
The end point setting function is only available for RADEMACHER electronic tubular motors
from 2000 onwards.
The end point setting can not be adjusted for tubular motors connected in parallel.
Select and open menu 9.8.9 - End points.
1.
Select a DuoFern actuator. [ ALLE ] (ALL) is
2.
is not possible for this function.
You can send a brief test signal in order to
a)
identify the DuoFern actuator.
Set the upper end point.
3.
Press and hold the set button. The roller
a)
shutters travel upwards.
Release the button as soon as the desired
b)
end point is reached.
62
The actuator executes
a brief movement or
switching command by
way of confirmation.
The upper end point is thereby stored for
the motor.
EN