Removing The Processor From The Processor And Heat Sink Module - Dell EMC PowerEdge T440 Installation And Service Manual

Figure 71. Removing the processor and heat sink module
Next steps
Install the processor and heat sink

Removing the processor from the processor and heat sink module

Prerequisites
NOTE: Only remove the processor from the processor and heat sink module if you are replacing the processor or heat sink.
This procedure is not required when replacing a system board.
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. Remove the air shroud.
4. Remove the processor and heat sink
Steps
1. Place the heat sink with the processor side facing up.
84 Installing and removing system components
module.
Safety instructions.
Before working inside your
module.
system.