Installing A Cabled Power Supply Unit - Dell EMC PowerEdge T440 Installation And Service Manual

Figure 82. Removing a cabled PSU
Next steps
1. Install a cabled power supply
2. Follow the procedure listed in

Installing a cabled power supply unit

Prerequisites
1. Follow the safety guidelines listed in
2. Unpack the replacement power supply unit (PSU).
Steps
1. Slide the new PSU into the PSU cage until the PSU is fully seated.
2. Tighten the screw to secure the PSU to the chassis.
3. Connect all the power cables from the PSU to the system board, drive backplane, and drives.
unit.
After working inside your
Safety instructions.
system.
Installing and removing system components 93