Removing A 3.5-Inch Drive Adapter From A 3.5-Inch Drive Carrier - Dell EMC PowerEdge T440 Installation And Service Manual

Figure 34. Installing a 2.5-inch drive into a 3.5-inch drive adapter

Removing a 3.5-inch drive adapter from a 3.5-inch drive carrier

Prerequisites
1. Follow the safety guidelines listed in
2. If installed, remove the front
3. Remove the 3.5-inch drive carrier from the
Steps
1. Using a Phillips #1 screwdriver, remove the screws from the rails on the drive carrier.
NOTE: If the hard drive or SSD carrier has Torx screw, use Torx 6 (for 2.5-inch drive) or Torx 8 (for 3.5-inch drive)
screwdriver to remove the drive.
2. Lift the 3.5-inch drive adapter out of the 3.5-inch drive carrier.
46 Installing and removing system components
Safety instructions.
bezel.
system.