Initializing Tpm For Bitlocker Users; Initializing The Tpm 1.2 For Txt Users - Dell EMC PowerEdge T440 Installation And Service Manual

Removing the TPM
Steps
1. Locate the TPM connector on the system board.
2. Press to hold the module down and remove the screw using the security Torx 8-bit shipped with the TPM module.
3. Slide the TPM module out from its connector.
4. Push the plastic rivet away from the TPM connector and rotate it 90° counterclockwise to release it from the system board.
5. Pull the plastic rivet out of its slot on the system board.
Installing the TPM
Steps
1. To install the TPM, align the edge connectors on the TPM with the slot on the TPM connector.
2. Insert the TPM into the TPM connector such that the plastic rivet aligns with the slot on the system board.
3. Press the plastic rivet until the rivet snaps into place.
Figure 94. Installing the TPM
Next steps
1. Install the system board.
2. Follow the procedure listed in After working inside your system.

Initializing TPM for BitLocker users

Steps
Initialize the TPM.
For more information, see .
The TPM Status changes to Enabled, Activated.

Initializing the TPM 1.2 for TXT users

Steps
1. While booting your system, press F2 to enter System Setup.
2. On the System Setup Main Menu screen, click System BIOS > System Security Settings.
3. From the TPM Security option, select On with Pre-boot Measurements.
4. From the TPM Command option, select Activate.
5. Save the settings.
104 Installing and removing system components