Figure 67. Removing the MicroSD card
NOTE:
Temporarily label each MicroSD card with its corresponding slot number after removal.
Next steps
1. Follow the procedure listed in
2.
Install a MicroSD card.
Installing the MicroSD card
Prerequisites
Follow the safety guidelines listed in
NOTE:
To use an MicroSD card with your system, ensure that the Internal SD Card Port is enabled in System Setup.
NOTE:
If reinstalling, ensure that you install the MicroSD cards into the same slots based on the labels you had marked on
the cards during removal.
Steps
1. Locate the MicroSD card connector on the IDSDM/vFlash module. Orient the MicroSD card appropriately and insert the
contact-pin end of the card into the slot. To locate IDSDM/vFlash, see
NOTE:
The slot is keyed to ensure correct insertion of the card.
2. Press the card into the card slot to lock it into place.
80
Installing and removing system components
After working inside your
Safety
instructions.
system.
Jumpers and
connectors.