Connect; Connector Identification; Connection Procedure - Omron Sysmac NY Series Hardware User Manual

5-5

Connect

This section describes how to connect the IPC Machine Controller.
5-5-1

Connector Identification

An overview of the connectors is available in the overview of Layers.
Refer to 3-1-2 Base Layer on page 3-5 for connector details.
5-5-2

Connection Procedure

Use the following procedure to connect the IPC Machine Controller.
Ensure the Box PC is securely fastened to the mounting surface.
Ensure the mounted Box PC can be connected to power and peripheral devices. Remove dust covers
where applicable and store them in a safe place.
Additional Information
• Refer to 5-3 Mount on page 5-15 for mounting details.
• Refer to 3-10 Optional Hardware on page 3-23 for the cables advised by Omron.
Refer to individual cable specifications for cable bending requirements and connector clear-
ance.
Use the following procedure to connect the Box PC:
1
Ensure the ground terminal is connected.
Refer to 5-4-2 Ground on page 5-28 for grounding details.
2
Connect the power connector A .
Hold the black part to enable the auto-locking mechanism.
Do not push the orange sliders B in the direction of the Box PC because this will unlock the
connector.
NY-series Industrial Box PC Machine Controller Hardware User's Manual (W556)
A
B
5 Installation
5
5-41