Initial Power On; Initial Power On Procedure - Omron Sysmac NY Series Hardware User Manual

5-6

Initial Power ON

This section describes how to Power ON the IPC Machine Controller for the first time.
Ensure that installation and post-installation checks of the product are performed by
personnel in charge who possess a thorough understanding of the machinery to be
installed.
5-6-1

Initial Power ON Procedure

Use the following procedure to power ON the IPC Machine Controller for the first time.
1
Ensure the following conditions are present before applying power for the first time:
• The Box PC is securely fastened to the mounting surface.
• The Box PC is connected to ground.
• All connectors are securely fastened.
2
Ensure that the connected monitor(s) is powered ON.
3
Connect a keyboard and/or mouse.
Additional Information
• If using an OMRON Industrial Monitor, this may not be required because it has touch func-
tionality.
• Do not connect additional storage devices before the installation of the operating system
completed. Adding storage devices like a USB flash drive, an SD memory card or a PCIe
card might influence the default drive letter sequence.
4
Ensure the power supply is ON.
Precautions for Safe Use
Always check the power supply and power connections before applying power. Incorrect power
connections can damage the product or cause burning.
5
Press the power button and release within 1 second.
Refer to 3-3 Power Button on page 3-11 for the power button location.
The Box PC starts and the PWR LED will go ON.
6
Verify the ERR LED is OFF.
The Industrial Box PC is ON and the Operating System starts.
Additional Information
Refer to the NY-series IPC Machine Controller Industrial Panel PC / Industrial Box PC Setup
User's Manual (Cat. No. W568) for details on how to continue the setup.
NY-series Industrial Box PC Machine Controller Hardware User's Manual (W556)
WARNING
5 Installation
5
5-47