Torque Instructions - VERDER VERDERAIR VA-E25 Operation

Torque Instructions

Torque Instructions Instructions
Torque Torque Instructions
If fluid cover or manifold fasteners have been
loosened, it is important to torque them using the
following procedure to improve sealing.
NOTE: Fluid cover and manifold fasteners have a
NOTE: NOTE:
thread-locking adhesive patch applied to the threads.
If this patch is excessively worn, the fasteners may
loosen during operation. Replace screws with new
ones or apply medium-strength (blue) Loctite or
equivalent to the threads.
NOTE: Always completely torque fluid covers before
NOTE: NOTE:
torquing manifolds.
Fluid Cover Fluid Fluid Cover Screws Cover Screws Screws
22
1. Start all fluid cover screws a few turns. Then, turn
down each screw just until head contacts cover.
2. Turn each screw by 1/2 turn or less working in a
crisscross pattern in the order shown to specified
torque.
3. Repeat for manifolds.
Fluid Fluid Fluid cover cover and cover and and manifold manifold fasteners: manifold
(90 in-lb)
Inlet Inlet and Inlet and and Outlet Outlet Manifold Outlet Manifold Screws Manifold
fasteners: 10.2 N•m fasteners:
Screws Screws
859.0510