Table of Contents
Advertisement
Operation
Torque Settings
Select the desired torque setting before operating the screwdriver.
To modify the torque setting, do the following:
■
To increase the torque, turn the regulating handle clockwise.
■
To decrease the torque, turn the regulating handle counterclockwise.
When the selected torque is reached, the internal clutch disengages and a click is heard. This indicates
that the power to the motor is cut off.
Use a torque meter to check that the tool is set to the desired torque. The engraved marks on the ring are
just for reference.
Secure the regulating handle with a torque cover to prevent torque changes.
Do not use the screwdriver over the 80% of the rated maximum torque to avoid inaccurate clutch es-
cape.
Operating Instructions
Tighten Joint
To tighten a joint, do the following:
1.
Slide down the button on the handle of the screwdriver to set the tool in forward mode.
2.
Place the tip of the screwdriver on the screw.
3.
Press the trigger and push the bit towards the screw and work piece. The trigger must be pressed
during the whole tightening process.
The power adapter gives information about the tightening process:
■
If the tightening process is performed correctly, the power adapter will show a green light.
■
If the tightening process is performed incorrectly, the power adapter will show a red light.
Do not change the running direction of the screwdriver while in operation, wait until the tool has
stopped.
12
EN
© Atlas Copco Industrial Technique AB - 9839 2054 01
S8020-WS
Advertisement
Table of Contents
