Table of Contents
Advertisement
S8020-WS
Accessories
EBS D Power Adapter
The EBS D Power Adapter is an accessory provided with the tool. Use this universal power source only
with applicable screwdrivers (S8020, S8020-WS, S8050, S8120, S8120-2000, S8160, S8200 and S8250).
Installation
Position the power adapter on a stable surface and keep its surroundings clear to allow heat dissipation.
Connect the power adapter to the tool using the supplied cable. Make sure that the guide notch is aligned
with the convex point in the socket, then twist it to fix it in the drive.
Power Setting
The input voltage of the power adapter is ranged from 100 to 240 VAC and from 50 to 60 Hz. Make sure
to use the correct voltage to avoid any damage to the power adapter.
To switch on the power adapter, do the following:
1.
Connect one side of the cable to the AC power socket and the other side to the AC input socket (C13
specification).
2.
Change the position of the two-stage switch on the power adapter to ON mode.
To switch off the power adapter, do the following:
1.
Change the position of the two-stage switch on the power adapter to OFF mode.
2.
Disconnect the cable from the AC power socket and from the AC input socket (C13 specification).
Output Plug (DC)
The output plug provides power to the screwdriver.
The plug specifications are the following ones:
There are two terminals at the bottom of the power adapter:
EN
© Atlas Copco Industrial Technique AB - 9839 2054 01
Product Information
5
Advertisement
Table of Contents
