Advertisement
Chapter 5
Finishing Installation
The steps in this chapter should only be performed by, or after receiving approval from, an authorised
ETC representative.
Check Backplane DIP Switches
The backplane of your rack features a set of eight DIP switches allowing configuration of the rack type.
The CEM3 reads these DIP switches to determine the rack type, phasing and available modules.
Compare the position of these DIP switches to the table below and, if necessary, set them to the
correct position using a jewellers screwdriver.
Use the following chart to determine your required DIP switch settings:
ESR3-12
ESR3-12N
ESR3-12AF
ESR3-12AFN
ESR3-24
ESR3-24N
ESR3-24AF
ESR3-24AFN
ESR3-36
ESR3-36N
ESR3-36AF
ESR3-36AFN
ESR3-48
ESR3-48N
ESR3-48AF
ESR3-48AFN
Energising the System
You need ETC approval to apply power to your dimming system. Wiring errors in unauthorised
installations may endanger operators or cause system damage and failure.
WARNING:
CAUTION:
Finishing Installation
Rack Model
1
Do not attempt to energise the system without proper approval.
Energising the system without ETC approval may result in serious
injuries.
Energising your system without ETC approval may result in equipment
damage that may void your warranty!
DIP Switch Number
2
3
4
5
On
On
On
On
On
On
On
On
On
On
On
On
On
On
On
On
On
On
On
On
On
On
On
On
On
On
On
On
On
On
On
On
6
7
8
On
On
On
On
On
On
On
On
On
On
On
On
29
Advertisement
