Advertisement
Floor Mounting Racks Using Vibration Pads
ESR3-36 and ESR3-48 racks can be floor mounted on optional
vibration damping fittings (ETC Part# HW6109).
Step 1:
Note:
Step 2:
Step 3:
Step 4:
Step 5:
Step 6:
Step 7:
Step 8:
CAUTION:
Installation of Racks
Determine where your rack will be installed using
Figure 1: Sensor3 rack clearances on page
Be sure this mounting method complies with
local building and electrical codes.
Level racks before marking the hole positions.
Use the appropriate diagram from
diagrams for mounting racks to the floor on
page 11
to mark your hole locations.
Align the center of the vibration fitting over the
hole locations from the diagram. Mark the
positions for two bolts for each vibration pad.
Drill the holes and secure the pads to the floor. You must supply your own M8 mounting
hardware.
Remove the included bolt and washer from each vibration pad.
Position the rack on the pads so the center holes of the pads align with the mounting
holes in the base of the rack.
[Optional] If required, secure the rack to a wall using wall mount vibration pads (ETC
Part# HW6111). If the vibration pads have been requested for the installation, they are
included with the rack.
• Follow instructions from
in the back of the rack for wall mounting.
• Mount the rack to the wall using the procedure from
Vibration Pads
page
on
Secure the rack to the pads with the included bolts.
Unless the all mounting and connections are done in a flexible manner, the
effectiveness of the vibration pads will be reduced or completely negated.
This includes the use of wall vibration pads when mounting to the floor and
at least 30 cm of flexible conduit or flexible cable for all of the electrical
connections to the rack(s).
8.
Figure 2: Hole
Securing Sensor3 Racks to a Wall
12, above.
Center the fitting over the mount hole location
from the diagram and mark the positions for the
fitting hardware
38 mm
38 mm
Figure 4: Floor vibration pad
page 11
on
to drill holes
Wall Mounting Racks Using
ETC Part#
HW6109
13
Advertisement
