Advertisement
Securing Multiple Racks (Optional)
Multiple racks can be connected to each other for greater stability.
Note:
Step 1:
Note:
Step 2:
Step 3:
Step 4:
14
If you want to install the control cable through the side of the racks, you should
remove the side cable knockouts before connecting the rack.
Use M8 spin lock bolts and lock nuts in the front and at the back to bolt the racks
together at the bottom.
Hole for bolting
racks together
(recessed)
The front bolt is difficult to reach – you may need a magnetic bolt-driver or socket
extension.
(ESR3-36 and ESR3-48 only) Remove six screws from the tops of adjacent racks, as
shown below.
Temporarily remove
six screws from this
area
Figure 6: Screws to remove to connect two racks
(ESR3-36 and ESR3-48 only) Place a rack splice plate over the empty screw holes and
replace the screws you removed in Step 2 as shown above.
Repeat Steps 1, 2 and 3 until you have secured all the racks.
Figure 5: Placement of rack connecting holes
Hole for bolting
racks together
Install the rack splice and
replace the screws to
secure it
Sensor3 CE Rack (ESR3) Installation Manual
Advertisement
