HP NetServer E 60 Installation Manual page 58

Chapter 9 Configuring the NetServer Using the HP NetServer Navigator CD-ROM
to Windows NT systems. The Local TopTools for Servers program is a
stand-alone support tool accessed directly from the NetServer. It gives
you information to help you manage the NetServer.
◊
Select No for manual NOS installation. A manual NOS installation is
the default if you are installing a NOS other than certain versions of
Novell NetWare or Microsoft Windows NT Server, and also should be
used if you have replaced any HP components with non-HP
components other than Network Interface cards on the TPL.
•
Configure ISA Non-Plug-and-Play Board: If you have installed an ISA
non-Plug-and-Play board, and you have not reserved system resources for
it, select Configure Non-PnP board on the information window that
pops up.
•
View Configuration Advisories: Read the configuration advisories, and
print them if necessary. You can change your hardware at this time to
conform to the advisories.
•
Show System Information: Use this screen to display information about
standard and accessory boards and devices in the system, as well as the
used and available system resources.
◊
Select View System Information on the Show System Information
screen to display information about standard and accessory boards
and devices in the system.
◊
Select View Resources on the Show System Information screen to
display used and available system resources, such as memory ranges,
I/O port ranges, DMA channels, and interrupt (IRQ) levels.
•
Configure Disk Array: If you have an HP disk array, you must configure it
with the disk array utility. Select Execute on the Configure Disk Array
screen to start the Disk Array utility.
•
Install Utility Partition: This step creates a 32 MB utility partition on the
server hard disk where HP Navigator will copy DiagTools, the BIOS
update utility, the disk array utility, the NIC configuration utility, the
Remote Console feature, troubleshooting utilities, and other utilities. It is
not available for SCO UNIX. Select Execute on the Install Utility
Partition screen.
•
Execute Board Utilities: When Configuration Assistant detects installed
boards for which there are additional configuration utilities on the HP
NetServer Navigator CD-ROM, you can execute these utilities to complete
52