HP NetServer E 60 Installation Manual page 72

Chapter 11
6. Use the up and down arrow keys to highlight ISA non-Plug-and-Play
Devices, and press Enter to select that submenu.
7. Use the up and down arrow keys to highlight Memory Resources, and
press Enter to select that submenu.
8. Use the up and down arrow keys to highlight the memory block that
corresponds to the memory range required for the ISA board you are
installing, and press the + or - key on the keypad to reserve it. If the
memory range required for a board spans two or more blocks shown on
the screen, reserve all blocks required by the board. If the memory range
required for the board is less than one block, select the whole block that
contains the range.
9. When all the necessary memory blocks are reserved, press ESC to return
to the ISA non-Plug-and-Play Devices submenu.
10. Use the up and down arrow keys to highlight the DMA Resources item,
and press Enter to select that submenu.
11. Use the up and down arrow keys to select the DMA channel that
corresponds to the DMA channel required for the ISA board you are
installing, and press the + or - key on the keypad to reserve it. Reserve all
DMA channels needed for the board.
12. When all the necessary DMA channels are reserved, press ESC to return
to the ISA non-Plug-and-Play Devices submenu.
13. Use the up and down arrow keys to highlight I/O Resources, and press
Enter to select that submenu.
14. Use the up and down arrow keys to highlight the I/O port block that
corresponds to the I/O port range required by the board you are installing,
and press the + or - key on the keypad to reserve that block. If the I/O port
range required for the board spans two or more blocks shown on the
screen, reserve all blocks required by the board. If the I/O port range
required for the board is less than one block, select the whole block that
contains the range.
15. When all the necessary I/O port blocks are reserved, press ESC to return
to the ISA non-Plug-and-Play Devices submenu.
16. Use the up and down arrow keys to highlight Interrupt Resources, and
press Enter to select that submenu.
66
Using the BIOS Setup and SCSI Select Utilities