HP NetServer E 60 Installation Manual page 33

Chapter 4
1. To install the external cable, connect one end to the free SCSI connector
on the System board (refer to the Technical Reference Card on the chassis
for location).
2. Using a flat blade screwdriver, pop out the external SCSI knock-out at the
rear of the system (see Figure 4-7 for location).
3. Thread the cable from the SCSI channel B connector, between the
processor cage and the factory installed AGP Video board, to the cutout at
the rear of the chassis (see Figure 4-6).
Figure 4-6. Threading External SCSI Cable
Installing Mass Storage Devices
27