Burlink; Connections; Commands - Burmester Top Line Phono preamp 100 Owner's Manual

Connections to the BURLINK interface can either be done by the 9-pin D-SUB connector (RS-232) or by the USB
connector.
RS-232 configuration: 9600Baud, 8bit, parity: none, 1 stop bit, no hardware handshake
A USB device driver needs to be installed when using the USB connector. System requirements for using the USB
software are either WINDOWS 2000 or WINDOWS XP operating system.
Listed below are the possible commands to control the preamp 100. All commands needs to be sent in capital letters
finished with a "carriage return" \r .
POWON\r
POWOFF\r
INP+\r
INP-\r
INP1\r
INP2\r
VOLUP\r
VOLDN\r
ADC\r
ADC_OFF\r
SUBS\r
SUBSONIC_ON\r
SUBSONIC_OFF\r
DIM\r
DIM0\r
DIM1\r
DIM2\r
DIM3\r

BURLINK

CONNECTIONS

COMMANDS

switches the unit on
switches the unit to standby mode
toggles the inputs of the preamp
toggles the inputs of the preamp
switches to input 1
switches to input 2
increases the volume by one step
decreases the volume by one step
switches the ADC on and toggles the sampling frequency between 48kHz, 96kHz
and 192kHz
switches the ADC off
toggles the subsonic filter (on – off – on – off ...)
switches the subsonic filter on
switches the subsonic filter off
toggles the brightness of the display (0,1,2,3,0,1,2....)
switches brightness to maximum
switches brightness to middle
switches brightness to low
switches the display off
13