Connecting The Internal Battery - Eaton 9PX Lithium-Ion Advanced User's Manual

NOTE 1
NOTE 2
Remember If you ordered other UPS accessories, refer to specific user manuals to check the packing
contents.
3 3 . . 3 3 C C o o n n n n e e c c t t i i n n g g t t h h e e I I n n t t e e r r n n a a l l B B a a t t t t e e r r y y
NOTE
Figure 6. Internal Battery Connection
To connect to the UPS:
1. Remove the center cover of the front panel.
2. Push left cover toward to right direction.
3. Open the left side of the front panel.
NOTE
A small amount of arcing may occur when connecting the internal batteries. This is normal and will not harm
personnel. Connect the cables quickly and firmly.
4. Connect the two battery connectors together.
5. Put back the front panel, then clip the center cover.
Discard the EBM user's guide if you are installing the EBM with a new UPS at the same
time.
Use the UPS user's guide to install both the UPS and the EBM.
Do not connect the UPS to the utility until installation is complete.
1
2
4
A ribbon cable connects the LCD control panel to the UPS. Do not pull on the cable or
disconnect it.

Connecting the Internal Battery

5
CAUTION
Eaton 9PX Lithium-Ion P-164001006—Rev 01
3
15