5 O O P P E E R R A A T T I I O O N - Eaton 9PX Lithium-Ion Advanced User's Manual

Table 6. User Settings (Continued)
Submenu
LCD
Audible alarm
Protected
access
Output voltage
Output
frequency
Output mode
Input volt
In/Out settings hysteresis
High Efficiency
mode
Bypass settings
Load segments
Overload
prealarm
Start/Restart
On/Off Settings
Forced reboot
Available settings
Modify LCD screen brightness and
contrast to be adapted to room light
conditions.
Mode: [Enabled] [Disabled on battery]
[Always disabled] Enable or disable
the buzzer if an alarm occurs. Level:
[High] [Low]
[Enabled] [Disabled] Password is: 0577
100V] [110V] [120V] [125V]
[200V] [208V] [220V] [230V] [240V]
Mode: [Normal] [Converter] [Marine]
Frequency can be changed in
Frequency [Converter] mode In [Marine]
mode output frequency follows input
frequency
Mode: [Industrial] [IT] [Custom]
Overload: [Inv>Stop] [Inv>BP]
[Inv>BP>Inv]
Short-circuit: [Inv>Stop] [Inv>BP]
[Inv>BP>Inv]
Sets input voltage hysteresis from [1]
to |10V]
[Enabled] [Disabled] Power the output
from Bypass for high efficiency
[Volt low]
[Volt high]
[Qualify]
[Hz synch]
[Unsynch]
[Auto start delay]
[Auto shutdown delay]
[10%] ... [102%] Load % when
overload alarm occurs
[Cold start] [Auto restart] [Auto start]
[Start on bypass]
[Enabled] [Disabled]
[Timer] [10s] ... [180s]
When mains recover during a
shutdown sequence: If set to Enabled,
shutdown sequence will complete and
wait 10 seconds prior to restart, If set
Eaton 9PX Lithium-Ion
User Settings
Default settings
[Enabled] [High]
[Disabled]
[120V]
[208V]
[Normal]
[IT] [Inv>BP>Inv] [Inv>Stop]
[10V]
[Disabled]
[80V] LV; [160V] HV;
[144V] LV; [276V] HV;
[In spec];
[5%];
[Half cycle]
UPS: [0s]; Group1: [3s]; Group2: [6s] UPS:
[Disabled];
Group1: [Disabled]; Group2: [Disabled]
[102%]
[Cold start] [Auto restart] are Enabled
[Auto start] [Start on bypass] are Disabled
[Enabled]
[10s]
P-164001006—Rev 01 9