Eaton 9PX Lithium-Ion Advanced User's Manual page 28

Connection with a Hotswap MBP Module ( Optional Accessory)
9PX 2200GRT-L & 9PX 3000GRT-L
1
MBP
29
HotSwap MBP module operation
31 32
UPS start-up with the HotSwap MBP module
1. Check that the UPS is correctly connected to the HotSwap MBP module.
2. Set switch
33
3. Start the UPS by pressing the ON/OFF button
The load is supplied by the UPS.
LED "UPS ON - OK to switch" on the HotSwap MBP module goes ON.
31
HotSwap MBP module test
1. Set switch
33
2. Set switch
33
22 Eaton 9PX Lithium-Ion
28
30 31 32 33
LOAD
33
to Normal position.
to Bypass position and check that the load is still supplied.
back to Normal position.
P-164001006—Rev 01
5
1. Connect the input
HotSwap MBP module to the
AC-power source.
2. Connect the UPS input cable
6 7
the "UPS Input socket"
HotSwap MBP module.
3. Connect the UPS outlet
"UPS Output"
MBP module (using the cable
supplied for G models).
These cables and the connectors
are marked in red.
4. Connect the equipment to the
outlets
module. These outlets differ,
34 35 36
depending on the version of the
HotSwap MBP module.
Caution: when using HotSwap
15 MBP , do not use UPS outlets to
directly power equipment. As
operating the bypass switch
will cut supply voltage to the
equipment.
The HotSwap MBP module has a rotary
switch
33
Normal the load is supplied by the UPS,
Bypass the load is supplied directly by
on the UPS control panel.
on the
36
on the
35
to the
5
on the HotSwap
34
on the HotSwap MBP
29
33
with two positions:
LED is on.
31
the AC-power source. LED
32
is on.
to
1
28