Setting Up And Starting Up; Operating Elements; Connection; Starting Up - Atmos A 161 Operating Instructions Manual

3.0 Setting up and starting
1 2
Fig 2a.
2
Fig 2b.
Fig 4.
Fig 5.
3 5
6
Fig 3.
3.0 Setting up
 Set up the device on a level, fi rm surface.
3.1

Operating elements

1
Shove blind for covering the operating elements
(ATMOS C 161 / 261 Aspirator)
®
2
Vacuum adjustment
3
Vacuum gauge (ATMOS
4
Hose storage (fi g. 1, page 4)
5
Suction hose storage (accessory)
6
Switch On I / Off O
3.2

Connection

The main voltage specifi ed on the type plate must match
the power supply system.
Check mains cable for damages. Damaged cables must be
replaced immediately!
3.3

Starting up

●
The ATMOS A / C 161 / 261 Aspirator is delivered
®
ready for use.
●
Lift the unit out of the cardboard. Check whether the
voltage values on the data plate correspond with the
inbuilding voltage.
● Set up the device on a level, fi rm surface.
●
Prior to fi rst operation, pay attention to the safety
information in chapter 2.0.
●
The unit must be allowed to stand for up to six hours
at room temperature prior to starting up for the fi rst
time following transport at temperatures below
freezing. The unit may not be operated if it has not
acclimatised as this might damage its diaphragms.
●
ATMOS A / C 161 / 261 Aspirator / DDS: Always hold
®
ready at least one DDS bacterial filter, as the device
may not be operated without one!
C 161 / 261 Aspirator)
®
7