Table of Contents
Advertisement
4 - System setup
Footswitch remote
A footswitch can be fitted as an option to turn the spraying ON/OFF.
Note the following if the footswitch remote is to be fitted.
• The remote has to be activated from the extended controller
menu at installation - contact your HARDI service centre.
• The speed/switch wire harness (A) is connected to the Controller.
Connect the plug from the footswitch ON/OFF to the correct
connector on the wire harness (A).
μ
ATTENTION! The main ON/OFF valve switch on Spray Box III
(green button in the top right corner) overrides all remote
switches. This button must be set to ON (press it down) for the
footswitch remote to function.
Initial system start-up
When connecting the 39-pin plug from the sprayer, please note the
one-way brackets inside the connector and connector plug. There are
two different brackets designating connector plug for liquid (1) and
hydraulics (2) respectively.
μ
ATTENTION! The Controller/Terminal should be protected from
moisture and should be removed when not in use, if the tractor
does not have a cabin.
When the connector plug is connected to the socket, the locking pawl
(A) must click in place to secure the plug.
When disconnecting the plug, the locking pawl must be pushed back,
before the plug can be pulled out.
After connecting the plugs, the power is turned on at the red switch on
the Spray Box connected to the Controller.
The lamp below the switch will flash red, and then it turns green.
Press
to continue.
μ
ATTENTION! At the very first start-up, the time and date must be set in order to make the registers work properly (if
not preset from the factory). See menu [2.4 Set Clock].
Screen contrast adjustment
The screen contrast can be adjusted by pressing
be done when "working screen" is active, i.e. not when any menus are active.
Note that this function will only be available on hardware version 2.0 and higher.
26
and then use the
or
to find the correct setting. This can only
Advertisement
Table of Contents
