Configuration; Webconsole Overview; Connecting To The Udm-0102 - AMX Endeleo UDM-RX02 Operation/Reference Manual

Configuration

WebConsole Overview

Each UDM-0102 Hub can be configured for the correct network environment. It is also possible to
configure each Hub for the correct date and time. Configuration options are available via the UDM Hubs
built-in WebConsole, as described in this section.
The UDM-RX02 receiver connected to the UDM-0102 is also configured via the Hub's WebConsole.
This section describes the pages that comprise the UDM-0102's WebConsole
interface in the order that they are presented ("Status", "Setup", "Schedule" and
"Protocol"). However, on initial connection, you'll probably need to visit the Setup
page first, to specify network configuration and other basic device setup options for
the Hub.
See the Setup Page section on page 36 for details.

Connecting to the UDM-0102

1. With the TCP/IP address configured, connect the UDM-0102 to your network equipment (switch,
hub, or serial port) - or if required use an Ethernet Crossover cable to connect your PC directly.
2. Enter the IP address into the address field within a browser window.
The default IP address of the UDM-0102 is 192.168.0.96.
3. To connect to the UDM-0102, a password is required (FIG. 17).
FIG. 17 UDM-0102 Login screen
The password is case sensitive.
UDM-0102 and UDM-RX02 Operation/Reference Guide
The username should be left blank.
The password is admin.
Configuration
21