Connecting A Vga Video Input; Connecting A Component Video Input; Connecting An S-Video Input; Connecting A Composite Video Input - AMX Endeleo UDM-RX02 Operation/Reference Manual

UDM-0102 Wiring and Connections
The UDM-HD15RCA3F Endeleo HD15 to 3x RCA Breakout Cable
(FG-HD15RCA3F) referenced in the table above is different from a standard RCA
cable, and an RCA cable cannot be used in its place (the Y, Pb, and Pr connections
are shifted from the VESA standard). If a standard cable is to be used, you will have
to swap the connectors. Contact AMX Technical Support for details.

Connecting a VGA Video Input

1. Connect one end of a VGA cable to the source device's VGA output port.
2. Attach the other end of the cable to the appropriate VIDEO IN connection (A or B) on the UDM.
For example, connect to the Video In connection on Input A of the Hub.
3. Connect any audio to the analog (RCA) audio connectors or digital (SPDIF) connector.
Ensure Input A is configured as a "VGA Input" and named appropriately within the
"Inputs" section of the UDM's built-in WebConsole. Also ensure the correct Audio
Type (Analog L/R or S/PDIF) is selected for the relevant input. Refer to the
Configuration section on page 21 for details.

Connecting a Component Video Input

1. Connect the UDM-HD15RCA3F Breakout Cable (FG-HD15RCA3F, not included) to the video
source device's Component video output connectors (Red, Green and Blue).
2. Attach the other end of the cable to the appropriate VIDEO IN connection (A or B) on the UDM.
3. Connect any audio to the analog (RCA) audio connectors or digital (SPDIF) connector.

Connecting an S-Video Input

1. Connect the UDM-SVID01 HD15 to SVideo cable (FG-UDM-SVID01, not included) to the video
source's S-Video connection.
2. Attach the other end of the cable to the appropriate VIDEO IN connection (A or B) on the UDM.
3. Connect any audio to the analog (RCA) audio connectors or digital (SPDIF) connector.

Connecting a Composite Video Input

1. Connect the UDM-HD15RCA3F Breakout Cable (FG-HD15RCA3F, not included) to the source
device's Composite output ports:
2. Attach the other end of the cable to the appropriate VIDEO IN connection (A or B) on the UDM.
3. Connect any audio to the analog (RCA) audio connectors or digital (SPDIF) connector.

Endeleo Video Adapter Cables

The following adapter cables are available from AMX, to allow connecting various video input types to
the UDM-0102:
Endeleo Adapter Cables
Name
UDM-HD15RCA3 FG-HD15RCA3
UDM-SVID01
10
A1 = red RCA
A2 = green RCA
A3 = blue RCA
FG # Description
Endeleo HD-15 to 3x RCA Breakout Cable
FG-UDM-SVID01 Endeleo HD-15 to S-Video Cable Breakout Cable
UDM-0102 and UDM-RX02 Operation/Reference Guide