Programming – System - Timings; Detectors Tab - Honeywell NOTIFIER AM-8200 Programming Manual

Through the arrow keys  select the line style (OPEN - LOOP)
Press the enter key
LINE STYLE: Open = Open Line, Closed = Closed Line
Protocol: ADV, CLIP: Configure the type of devices to handle.
ADV = Line managed with ADV protocol,
By selecting ADV the line can also handle up to 30 CLIP devices.
CLIP = Line managed with CLIP protocol (99 sensors + 99 modules)
Programming – System - Timings
In this sub-menu are programmed some delay times of the alarm outputs, the delay time for the sensor alarm
check, silencing inhibition, etc.
ALARM–OUT TAB
Timing of "Sounder delay" is expressed
in seconds, with values from 0 to 600 sec
max.
Press the ENTER key to activate the
editing function.
Use the arrow keys to enter the data;
press enter to confirm the entered data.
Through the arrow keys select the item which is required to be changed ("Siren" or "Tx Alarm")
Through pressure of the enter key
Through the arrow keys  or through keyboard the data are entered, by pressing the enter key
confirm entered data.
Sounder activation delay is programmable in seconds ( max. 600 sec)
The "Siren" and "TX Alarms" activation delay timings are active only in case of alarm if the immediate
activation of the outputs has been excluded in the exclusions menu.

DETECTORS TAB

Press the right Arrow key  to change the time of check for the detectors:
Detectors verification time allows the control unit to perform a check for all installed sensors, for the set time,
before confirming the possible alarm.
Detectors Verification Time is programmable in seconds ( Max. 50 sec )
N.B. This function will be effective only on the enabled sensors (refer to the Point Programming menu)
AM_8200
AM82000_manu-prog-ENG
to confirm the programming.
the editing function is activated.
Programming Manual
Doc. M-162.1-AM8200-ENG Rev A2
you can
PAGE - 15
NOTIFIER ITALIA