Output Modules For General Services; Connection Mode - Honeywell NOTIFIER AM-8200 Programming Manual

OUTPUT MODULES FOR GENERAL SERVICES

CONNECTION MODE

N.B.: the output modules used for the above-mentioned functions, do not accept CBE.
CONNECTION MODE
Resistore
Polarizzato
da
47ohm
PAGE - 38
NOTIFIER ITALIA
SOFTWARE
DESCRIPTION
TYPE_id
PWRC FORC Output module used to temporarily interrupt power supply, during
SYSTEM RESET, for the 4- wire conventional smoke sensors, powered by
a remote power supply. N.B.: this type SHALL NOT be programmed for the
SILENCING
GPND FORC output module activated at each alarm or Fault It is reset by ACK.
APND FORC output module activated at each alarm. It is reset by ACK
GAC FORC output module activated at each alarm. It is reset by RESET.
TPND FORC output module activated at each fault. It is reset by ACK or through
the Fault RESET
GTC FORC output module activated at each fault. It is reset by RESET.
TRS FORC output module activated at each FAULT. It is only reset through the
Fault RESET.
ZFLT FORC output module activated at each FAULT in the zone where is
associated. It is only reset through <Fault removing from the zone
ZDIS Output module activated in case of exclusion of a point or a zone.
MAINF Output module (non supervised output) activated when a MAINS Fault is
present
REM FORC output module activated from a remote command (supervisory SW)
GAS CON output module activated at each alarm. It is reset by RESET.
GTS CON output module activated at each fault. It is reset by RESET.
ZFLTC Output module activated in case of zone fault to here is associated
MAINFC Same as MAINF but supervised output
REMC CON output module activated from a remote command (supervisory SW)
SOFTWARE DESCRIPTION
TYPE_id
GASV
CON output module activated at each alarm
It is reset by RESET.
GTSV CON output module activated at each fault. It is reset by RESET.
(Complies to VdS 2489).
ZFLTV Output module activated in case of zone fault to here is associated
(Complies to VdS 2489).
MAINFV
CON output module activated
(Complies to VdS 2489).
REMV CON output module activated from a remote command (supervisory SW)
(Complies to VdS 2489).
SND Software type_ID only for the following Models: WMSS, WMS, WMS,
DBSS, DBS
activated at each alarm
STR Software type_ID only for the following Models: WMSS, WMSB,, DBSS
activated at each alarm
Programming Manual
Doc. M-162.1-AM8200-ENG Rev A2
.
(Complies to VdS 2489).
in case of Power Supply Fault
, follow the Sounder Output status
, follow the Sounder Output status
AM8200_manu-prog-ENG
AM_8200