Showven SPARKULAR JET User Manual page 5

3. Setting Menu:
Press "MENU"switch through setup menu.
Set DMX Address
Set Pressure
Manual Fountain
Manual Clear
4. Advanced Menu:
Press "MENU" 3 seconds to enter the advanced setup interface, press MENU key to enter
different options, wait 3 seconds to return to the main interface.
Options Range
SetTemperature 580-620
Auto Heat ON/OFF
Jet Delay* 0.5-2.0s
Factory Mode
Mode Selection
User Mode
Tip Over Error ON/OFF
Standby Switch ON/OFF
* Please don't change default value without engineer's suggestion from SHOWVEN.
Set DMX address.
1-512
If controlled by Host Controller, please set DMX address
as 1, 3, 5, 7,...2n-1, otherwise it may leads to signal
interference
Adjust the pressure value: 35 with lower effects height;
35/45
45 with higher effects height
ON/OFF Manual firing. Please be careful, do NOT close to the nozzle
Manual clear material. Please be careful, do NOT close to
ON/OFF
the nozzle
Explanation
Set inner core temp.
Auto heat ON/OFF when switch on machine
Firing delay set, time delay between press firing on
DMX/controller (firing trigger) and actual sparks out
from the nozzle.
Factory mode is for engineer only. When in Factory
mode machine can't controlled by DMX console/host
controller
Tip over ON/OFF
Standby function. When ON, the machine can firing
only when heating up was finished
SHOWVEN SPARKULAR JET USER MANUAL -4-