About This Manual; System Description - Eddyfi Technologies Magg 310 Manual

About This Manual

This manual has been prepared to assist you in the operation and maintenance of your Eddyfi
Technologies equipment. Correct and prudent operation rests with the operator who must thoroughly
understand the operation, maintenance, service, and job requirements. The specifications and
information in this manual are current at the time of printing.
This product is continually being updated and improved. Therefore, this manual is meant to explain and
define the functionality of the product. Furthermore, schematics or pictorials and detailed functionality
may differ slightly from what is described in this manual.
Eddyfi Technologies reserves the right to change and/or amend these specifications at any time without
notice.
Information in this manual does not necessarily replace specific regulations, codes, standards, or
requirements of others such as government regulations.
This manual copyright © 2021 by Eddyfi Robotics Inc. All rights reserved.

System Description

The Inuktun Magg™ 310 is a magnetic tracked crawler capable of driving vertically or inverted along
ferrous surfaces. Additionally, the magnet modules allow the vehicle to pull longer lengths of tether than
could normally be achieved without magnets, when travelling horizontally in steel pipes or on steel decks.
The crawler features a high-definition camera with a full 360-degree continuous tilt range and minimal
viewing obstruction near the back of the vehicle. The vehicle uses two extended 4000 series Microtracs™
mounted underneath the main chassis plate and can be moved up or down to accommodate different
pipe sizes and configurations.
Document: umed018307
Source Location: C:\epdm\isleng\products\ed-magghd\manuals\umed018307.docm
Revision: A01 Created by: ST
Magg™ 310
Date: 24 Feb 2021 IPN: 3097222-A01
Page 4 of 30