Microtrac™ Maintenance; Tether Re-Termination - Eddyfi Technologies Magg 310 Manual

The controller and power supply contain panel mount fuses for both AC and DC voltages. These fuses
are for the safety of the operator(s) as well as to protect the equipment from damage. If a fuse blows, stop
and look for possible causes. Causes might include cable damage, water incursion or improper
connections. See the controller manual for fuse replacement.
Fuse values have been carefully selected for their application. Always replace the fuses with the same
type and rating.
Caution: Disconnect the power source before checking or replacing fuses.
Microtrac™ Maintenance
Refer to the Microtrac manual for Microtrac™ 4000 maintenance and servicing instructions.

Tether Re-termination

Tether termination is a specialized service beyond the scope of this manual. Contact Eddyfi Technologies
if the tether is damaged or requires re-termination.
Document: umed018307
Source Location: C:\epdm\isleng\products\ed-magghd\manuals\umed018307.docm
Revision: A01 Created by: ST
Magg™ 310
Date: 24 Feb 2021 IPN: 3097222-A01
Page 26 of 30